Finished shrinking the starboard wing Oratex and attached the wing tip mounting strips. I remember back when I fabricated the strips where I read on the forum that care needed to be taken placing the rearmost nutplates so that they do not interfere with each other. As I was attaching the strips, I was thankful to whomever posted that because they are close and could easily cause issues. I am really happy with the way the wing turned out and felt much better starting on the port wing. That one is a bit more complicated since the pitot system, OAT probe and the GMU11 are located on that wing and need to be installed before closing the wing up. Needed to run the wiring for the heated pitot tube down behind the gas tank before covering the lower half of the wing. The rest of the stuff gets installed before the upper half gets installed.